clear bra...hella expensive...ask people in your regional forum

youd need to get it professionally done

ive heard of a few people trying it themselves and they fvcked up hardcore

how do i get to my forum WTF???????

^wes, buy the pre cut 3m clear bra off ebay its alot cheaper off there. Just make sure its the 3m one.

Thanks guys, i'm peelin that junk off tomorrow

^ k thanks and what shops put it on ?

thanks i feel white SOUTH ****

i got mine for like 400

Dont do that, precut films made for DIY cover less area because of the need to form around curves, and if its a professionally cut kit, then I guarantee you will put creases in it when you try to install. Leave the clearbras to the pros, heck some pros can't even get it right everytime

My last car (Prelude) had all kinds of abraisions in front of the rear wheel arch when I sold it with 80k miles on it. Why would you take it off? Its not like you can see it and its a protectant. If you dont like the way this little piece of plastic looks you're never going to like the way a clear bra looks.

Leave it on there. At least its clear and not black like they were on Porsches back in the day.

Wow lots of newbness goin on in this thread

Do NOT buy clearbra off ebay. Do yourself a favor and go to a professional installer that'll do it for you. While it may be $$$, if you really want to protect your front bumper/hood/side mirrors even then get it.

^^ and yah, why would you take it off? its there for a raeson and not very obvious to see. It helps with a lot of the chips there. I wish my front bumper came with one!!

its the qtr panel rock chip guard, and it comes off just like any clear bra and tinit, it might leave a residue behing but u can easy remove that, i just hope its not lighter then ur car, as u know when u remove stuf flike that sometimes ur car is a bit faded and under there its like the new paint =0/

good luck tho

Yeah I will probably just leave it but IMO it doesn't help much if any. I agree with getting a professional to do one, i'm not a newb haha, but if you want a cheaper route I was just throwing out there the ebay precut 3m and then getting it installed. If it was me? I'd say screw it, I just got my entire hood and front bumper repainted for 350 bucks so after a year just throw on some new paint. If clearbras were cheap? i'd get one of those haha

It does help. You think it's in a weird spot, but with the way our rear wheel wells bulge out, you'd be suprised how much debris ends up banging that spot on your car. I'd keep it on.