I know that the 350z has a bolt in one made by cusco, but is there anything out there for the G. I want to get a bolt in one first and see if I want to keep it in there then later weld it. I plan on taking out the back seats and getting sparco seats in the front with a 4 or 5 point harness. Yes I now that I don't need this yet, but I plan on tracking the car, and like the comfort feeling of the extra safety gear.

 

My Advice, Go Buy A Mustang Abd Ruin That, When You Start Drilling You Ruin The Integrity Of The Car, And Kill Its Value. Because Hte Person Buying It Will Kow It Was Abused. But I Wish You Luck And All The Safety.

 

I had the same in my hatchback, and threw that around the track. held up fine, so I welded it. as far as reselling the car. carpet will cover that up. I doubt that you pickup up the carpet to check the car the last time you bought used. I figure 95% of people that buy cars, don't remove panels and carpet to check for holes or extra welds that were later cut and sanded down. And I don't plan on selling the car anytime soon.

Last but not least the topic doesnt ask for anyones opinion or advice, it asks if anyone prefabs a cage for the car. So keep your opinions to yourself.

 

I gave you my advice, I guess the admins didn't find it useable... shame.

 

Get it when you need it then, It will look redonkeyless and be just a pain with your stock interior. Unless you will be spending a lot of time on the track and have a substantial amount of extra mods (power and suspension) to do your car I wouldn't put a roll cage in. You can have a shop fabricate one for your easily enough rather than purchasing one that is pre made for your car.

p.s. your stillen box is not cold air it's a short ram setup. It take the air and heat in from the engine bay, not from the outside.