Those are some good questions , I'll gladly answer them for you . You don't need a cold air intake just get a E46 performance chip with a upgraded boost control gauge and your set .

Oh and you don't need wheel spacers herrasunk is ftw

 

the E46 performance chip. can you elaborate?

 

the E46 performance chip took 10 years in the making. research and development yielded optimum performance gains adding 35 wrhp and 45 lbs of torque to our VQ. when coupled with FI, those aforementioned numbers DOUBLE, as you can retune the chip with a higher octane fuel.

however, to run this chip the fuel needed can only be mined from the tears of cambodian unicorns that are either in heat or in the midst of mating. they only mate once every 25 years.

 

Basically nailed it spot on. But you did leave 1 important thing out, you must upgrade the injectors to C14 double piston F14's high performance lines for optimal performance

 

but if do that won't i blow the welds off my intake?

 

It won't if you put the boost at around 2.8 psi while running racing fuel, you might want to get upgraded brake lines so the welds won't break off the intake manifold

 

you also have to make sure the little display reads "NW" or "SE" or it won't work. running an iso-nuclear thermal 5/16th spacer on each wheel will also reduce wheel spin, fyi.

 

Damn how did I forget about that thank god you chimed in and cleared that up. Btw make sure you get your car tuned so the ecu can remember the stock intake boost terminal with the new nos fogger system

 

I'm guess this tune uses up alot more gas. cremaster have u done this tune? It's only paired up with FI?

 

Welcome to the forum! First thing you'll want to do is lower your car by cutting the springs.

 

 

yes, i have done the tune. i had the fuel overnighted from cambodia and it's worked wonders w/ my forced introduction system, quad turbo set up, high flower cats, ceramic mid-pipe and gold induction muffler and tips.

 

Yessss

 

wow this is all very sick where can i get all of these parts? is there a vendor on here who sells these? i would like to do 500whp ad 600wtq all N/A with these bolts on

 

Pm nubzperformance on here , he will get you all the needed parts for your 600 hp N/A build . But make sure you put window washer fluid in your gas tank to get the air mass flow with all the pollutants in the air