ROTOR STUCK!! suggestions?
 

Alright, so I got 3 of the four rotors replaced and have had one hell of a time removing the RR rotor because it has severely corroded around the hub. I've used a wire brush to clean it, sprayed WD-40 like crazy. Banged all around it to see if it would break some of the rust off and nothing. There's a plate that covers the back side of the rotor except for the area where the caliper sits.. so I can't get even distribution of pressure. Any suggestions? TIA:bowrofl:

hand brake is holding it tight... hand brake is backside of rotor.

jus keep bangin all around, it should eventually get loose.

Bigger hammer and PB Blaster, just keep hitting it, it will break loose eventually.

Use a rubber mallet and don't be afraid to hit it hard. LOL!

PB Blaster around the hub and then hit it all around the area next to where the studs stick out (face of the drum). It will eventually pop. Just got to keep hitting it all around.

PB blaster and elbow grease

Need more than a rubber mallet. Dead blow hammer will be a better choice.

Internal drum e-brakes are a bytch.

+1 to what everyone else said.

fuuuck it im callin for a heavy duty dremel and cut everything off hahahaha just playin. my dad used his torch for lugs before and **** when they were stuck on then he smashed them off with old man strength!!!!

hahaha well I used the access hole for the e-brake adjuster and started chisseling away towards the hub. Eventually it cracked and on went the show. Thanks everyone..