I was irritated with the led’s in my heat switches being out, so i take them apart and pop em back together and presto they work again! on a side note, i do need new ones for the driver door. i’m heavily considering swaping over every led on the interior to blue or lime green led’s in everything. know where i could pick some up? just the factory ones will do for now tho! thanks in advance.

 

Ebay plcc-2 leds

 

lime green would be sickkk but youd have to replace the gauge leds? to make em match

 

myroncuz - TY!

OGKushRob - yea i think the green will be a good look. a bit time consuming tho - i have 2.5 more weeks of summer class, then i plan to swap them all.

 

eBay. Just type in the bulb size number followed by the word "led".

 

do you know if it this is the same size used in the gauge & dash? or is it just in panel switches?

 

tell me about it. i have till the end of july for summer classes. taking 10 credit hours..fml and i left early yesterday to watch the hawks win the Stanley Cup!!!!! haha school sucks. but my G wont pay for itself

 

keep me posted on your led adventure and maybe i shall follow suit with my G. i wanna go a good fluorescent-like green

 

your gauge cluster is a size 74 for 03-04's. the a/c control buttons are all plcc-2 with a combo of some 0805 leds.

 

Thanks very much, big time saver! now i dont have to break it all down. get sizes. put back together. wait til they arrive then begin!



yes, school blows. which is why i drive an 03 lol but when ever i make some progress i’ll post! i may do a green & blue combo fade on the gauge cluster and the rest green but only time will tell when i start poppin em in!

 

here some few website you can order some LEDS, and they are good.
http://www.superbrightleds.com/
http://www.v-leds.com/

 

I was literally just thinking this about my led's in my seat heater switches being out. I took the console apart and have the toggle switches out where I can mess with them but I can't figure out how to take it apart any further. I don't want to just pop the actual switch that you touch off for fear of breaking it. Any advice on what you actually did in terms of taking them apart? I can try to post pictures later if need be. Thanks

 

well if you just take the switch apart its easier than it sounds. two release clips from the console for each switch. then release the 2 on the switch that hold the top on bottom portion of the switch together. do it slowly, very slowly as there are free moving pieces that will move it you arent careful (make sure the bottom part is in a level position when you pull the switch housing apart) then there are two pieces, the led in black, and another one green i believe? on top you will see the led bulb. i just popped mine off made sure they were on the correct way and popped it back together. hope this helps. if you get me pics i can prob help you better. i dont have a camera or i would take pics of mine for you! GL!

 

Thanks for the tip, I will take some pictures to send to you this evening if I can. Its supposed to rain so might not be able to. I don't want to mess with it until I know that I am doing it right. I have the whole console taken apart anyways doing some cleaning of a soda that got spilled on my shifter and replacing the clock bulbs on the dash.

 

Lime green LED's........