Anyone made a custom harness bar for the back?
#1
Anyone made a custom harness bar for the back?
So I have been curious about this for some time now and to my knowledge I have never seen anyone that has made a harness bar that still allows for someone to sit in the back seat of a G. Does anyone know if this has been done before. I have had a couple funny custom ideas that may potentially work, but again wanted to see if anyone had successfully managed this project.
![Dunno](https://g35driver.com/forums/images/smilies/dunno.gif)
![Dunno](https://g35driver.com/forums/images/smilies/dunno.gif)
![Dunno](https://g35driver.com/forums/images/smilies/dunno.gif)
![Dunno](https://g35driver.com/forums/images/smilies/dunno.gif)
![Dunno](https://g35driver.com/forums/images/smilies/dunno.gif)
![Dunno](https://g35driver.com/forums/images/smilies/dunno.gif)
![Dunno](https://g35driver.com/forums/images/smilies/dunno.gif)
#3
I have had a few ideas, one was going low across the floorboard basically and just having some long harnesses, but that could be trouble. The other idea was to go basically across the headliner, but again that could get difficult with harness length.
I would think someone made something that is functional but still allows for back seat access.....or so I would hope
I would think someone made something that is functional but still allows for back seat access.....or so I would hope
#4
I have had a few ideas, one was going low across the floorboard basically and just having some long harnesses, but that could be trouble. The other idea was to go basically across the headliner, but again that could get difficult with harness length.
I would think someone made something that is functional but still allows for back seat access.....or so I would hope
I would think someone made something that is functional but still allows for back seat access.....or so I would hope
The purpose of the safety harness bar is to position the seat belt harness shoulder straps to min the angle of the pull point.
Harness should not be <45 degrees from top of shoulder to where they are mounted or pull over top of support bar. This is to min the compression force on your body and spine.
Thread
Thread Starter
Forum
Replies
Last Post
Hasanbaloch
Engine, Drivetrain & Forced-Induction
15
02-29-2024 08:45 PM
vstypicals
Buying, Selling & Leasing Discussion
6
07-20-2015 10:55 PM