In a few words for summary:**** THAT ****!@!@!@!@!@.

I removed the intake tube to get at the top left side bolts but after the first one wouldnt budge i said **** it. The one was fairly easy to get to with some long *** extensions. Top left 3 look easy but the right side looks like a PITA.

If any of u guys did it urself howd u get it done? I did soak the bolts in WD40 for a while.

 

Umm dude, get under the car and it can be in done in no time.

 

+1. the o2 sensors were a pain to get out, but def. get under the car.

 

Yo i was under the car and the bottom side looks easy. Its them damned top 3 bolts that are ****ed to deal with.

 

well yea it's gnna be hard but take your time.. if i could take my cats off, i'm sure you'll have no problem if you take your time.

 

Its an 03 that is driven in a high salt area. Already the bolts look a bit hammered. Ima give it another go on tuesday.

 

tell someone to give you a hand then

 

If i have time. I gota get ready to leave to the Philipines possibly this thursday or saturday then its off to singapore for a week.

 

buy some thread breaker to squirt on the bolts

WD40 works too, spray it on about every 10-15 minutes and do that for an hour or 2
let it soak in

much easier

 

i used a breaker bar to get mine off when i installed my turbo

 

werd.
Breaker bar is your best friend. Invest in one.