So... Throwing a po335 crankshaft sensor and a po327 knock sensor.
Symtoms: stalls when warm at a light when at idle.
Will only turn over after turning over for abount 3-5 seconds. When cool starts right up. I know that there are two camshaft sensors.... is it best to just replace both?
I just pulled the crankshaft sensor under the car... a little metal shavings on the magnet part of it..... probably not good....but does that mean its bad? any help would be great!
Thanks in advance

 

change the crank sensor. as far as the knock sensor, shine a light down under the intake manifold on the block and you will see the knock sensor bolted down in there....make sure a rodent hasnt feasted on the wires....cuz ive seen that happen. but a knock sensor code isnt gonna give you an extended crank.