Alright. I need some help. I CANNOT find a shop that will turn my cross drilled/slotted stoptechs. ANYONE know of a place that will do it?? I live in American Canyon and work in SF. So anywhere in between. THANK YOU ALL!!

 

I was in the same dilema....never winded up finding a shop. Most won't do it as they are afraid it will snap their cutting bit if not done properly. Good luck.

 

if you lived in south florida i would of resurface them for you. most people are stubborn and say you cannot do it but if they are still in sepcs there shouldnt be any problem just do small cuts at a time.

 

If you go to any brake shop they can do it. The bits are diamond tip and will not snap. I was a brake and suspension tech for over 5 years. Just make sure you are going to brake only shops. I know Just Brakes and Brake Masters are a few places that will do this. Not sure if you have any in your area tho. Hope this helps.

 

Dammit. I knew I shoulda moved to FL. Thanks anyway. I'll take a look around.

 

Also anyone with a on the car machine can do it with small cuts as stated before.

 

anyone that doesn't care about liability will do it.

 

Yep you should.