Hey Guys,

I need my front lower control arm bushings(translink) replaced. My originals are really worn out my translink is pushed to the front of the car and there is almost no bushing there. I did some research and bought some White-line Bushings to replace the OEMs. Unfortunately I don't have access to a press, is there any other way to get the bushings in? and Do i need to get an alignment after I replace the bushings? I'm trying to get this done asap.


Thanks.

 

Do you have a table vise?

I used a table vise and two sockets, one larger than the bushing and one smaller and pressed it out that way

 

Yes I do have access to one. Would that be enough force?