Hey, i have a friend who has a 350Z and im gonna help him install a set of ground wires. Can anyone give me some info on how to install them or refer me to a thread or sumthing. All and much information will help. Thanks
-Cameron
-Cameron
Registered User
Most kits usually come with the points where it should be grounded. Just clean them(possibly file to remove paint) and secure the point properly.
Don't worry too much about it so long as you don't gnd a 12v source. It is my opinion that most GND kits marketed will most likely cause GND noise pickup or loop rather than do anything else.
Don't worry too much about it so long as you don't gnd a 12v source. It is my opinion that most GND kits marketed will most likely cause GND noise pickup or loop rather than do anything else.
Lots of reading but go HERE for all the info you need.
Not a difficult install. Just look for the attachment points and don't overtighten on reinstall. (10-12 ft lbs. is enough)
C.
Not a difficult install. Just look for the attachment points and don't overtighten on reinstall. (10-12 ft lbs. is enough)
C.
Registered User
If you think the engineers left a pile of power on the table by saving a couple of yen on some additional wire your nuts. Grounding kits are a total placebo. Save your money and save your time - do something else.