I have done a DIY before but the outcome wasn't good. I think it had to do with the shape of the low beam area. I think with the G it will be easier. I will do it eventually, i have all the parts from my previous work.

 

That's better.

 

ttrank Ive done the project before with my 01 tl but after baking it the outer lens were messed up? and im to lazy to wet sand it and buffing it out. how did you do yours.

 

here you go

 

What temp did you bake them at and for how long? I have had mine in the oven three different times and don't have any problems with them.

 

I set mine at 250dg. and lefted them in for 2min then took them out and start pullin and stuck in back in. took me 3 trys. for each one. but the outer lens gets all flakey.

Thanks for the info.
-Loc

 

rijen,
yours look hella clean..... why does your hi's look yellow?

 

Hey,

TSX modified BIXENON for the top. used E46 shrouds with custom LEDS.
M45s on the bottom.
15watt LED turn signal with a projector lense for the signal.
PIAA 6600K bulbs for all four.

Ed Lin

 

^^^ wow me likey just from the description, mind posting some pics

 

TSX is not a bi-xenon; it's a low beam only. Did Larry somehow make them a hi/lo?

Is the bottom M45 projector and shroud?

 

His pics are up higher in this thread.

 

ttrank. well, MINE is NOW! :P bixenon...TSX projectors it is

Ed Lin

 

Ive got Bats 3/10 overlays on mine.

 

That's awesome. So the upper projector is Lo/Hi and the lower projector is just the fog? More like the 06' coupe lights.

 

All that must of cost more than 2 grand!!!!


Lovin' the blue and gold! Might go with that route but with bronze.