"X" drivetrain in a coupe
You'll need to swap the front suspension over as well. Slightly different to allow for the halfshafts.
I wonder if the coupe has the physical space underneath it to mount a transaxle?? I knows it's the same chassis, but the sheetmetal could be slightly different.
Possible need to swap the front cradle/engine support as well.
Plus you'd need to swap all the electronic controls and such as well
I wonder if the coupe has the physical space underneath it to mount a transaxle?? I knows it's the same chassis, but the sheetmetal could be slightly different.
Possible need to swap the front cradle/engine support as well.
Plus you'd need to swap all the electronic controls and such as well
Its been done on a 350z before, exact suspension from an 04 g35x
http://www.my350z.com/forum/mid-atla...wd-set-up.html
http://www.my350z.com/forum/mid-atla...wd-set-up.html
Last edited by Bestswat; Mar 29, 2010 at 10:36 PM.
Wouldn't really make much sense to do that with a coupe.
A RWD coupe weighs more than an equally equipped RWD sedan. sooo
It does make sense with the Z though, because it IS lighter.
Actually, it would be a lot easier to put the coupe front end on the sedan
A RWD coupe weighs more than an equally equipped RWD sedan. sooo

It does make sense with the Z though, because it IS lighter.
Actually, it would be a lot easier to put the coupe front end on the sedan
Thread
Thread Starter
Forum
Replies
Last Post
djreinx
Engine - Electrical
3
Dec 10, 2015 01:48 AM





