My memory switch trim panel recently fell out of the left side of the driver's seat. I simply pushed it back in but it is loose and won't stay. It looks like it might have had 3 or 4 spots along the top of it where the plastic was melted to the seat trim to hold it in.

I am just trying to find out if anyone else has had this problem and what they did. Only thing I can think to do is glue the top portion to the seat trim, but am reluctant to go ahead with this (somewhat) permanent solution for fear I might need to remove it at some point in the future.

Suggestions?

 

Use a couple of dabs of clear silicone or very small pieces of double sided tape to hold it in. Easy enough to get off in the future if you need to.

 

Thanks BlueDream. Good idea.

 

No worries, that's one of the reasons we're here...........