Launching the G35x
Launching the G35x
Wats the best way to launch the G35x from a dig?? Is it best to just floor it or hold down the break at the same time give a little gas then let of the break and floor it?? Wat gives the better result??
Thanks.
Thanks.
My best results came from pressing the brake HARD, foot on the outside edge. I wait until the last possible second to press the gas to the floor, releasing the brake about 1/2 sec after the gas pedal hits the carpet.
Don't bother with the snow switch-----you will have plenty of traction with the 25/75 split front/rear.
Don't bother with the snow switch-----you will have plenty of traction with the 25/75 split front/rear.
Similar to above-This is a brake stand.
With VDC off-
Apply lot's of pressure to the break pedal.
Apply half throttle or so-Not necessary to floor it, probably want about a few thousand rpm.
As you release the break pedal, nail the throttle to the floor.
With VDC off-
Apply lot's of pressure to the break pedal.
Apply half throttle or so-Not necessary to floor it, probably want about a few thousand rpm.
As you release the break pedal, nail the throttle to the floor.
Thread
Thread Starter
Forum
Replies
Last Post
Claudiu
V36 Brakes, Suspension, Wheels & Tires
3
Mar 10, 2018 11:38 AM
FS[NorEast]: New OEM G35x Compression Rods - Save!!
The Fixer
Steering & Suspension
15
Nov 1, 2015 03:26 PM




