Injen Cold air intake question...
Injen Cold air intake question...
I have a 2005 g Coupe.. i installed the injen cold air but in short ram setup.. i feelll a big reduction in my pickup.. i did not put the full cold air because i was scared of water gettting into the engine.. is there anyway around it?? and could someone shead some light why i am loosing power?
did you check to see if all your connections where one correctly.
I don't know where you live but unless you live in an area with lots of rain then dont worry about water going in the intake. I would try to install the whole thing and see if you get the same feel.
Recheck your install aswell. I have heard of some people loosing power in the low end rpms and gain a little at the top end. Try a search and you maybe able to find answers. Good luck.
I don't know where you live but unless you live in an area with lots of rain then dont worry about water going in the intake. I would try to install the whole thing and see if you get the same feel.
Recheck your install aswell. I have heard of some people loosing power in the low end rpms and gain a little at the top end. Try a search and you maybe able to find answers. Good luck.
Originally Posted by jigied4lif
i just checked my connection.. the sensor on the tube is not bolted on... its is in the tube but just hanging ... do u think this is the problem...
Its not reading A/F properly then... plug that biatch in
Thread
Thread Starter
Forum
Replies
Last Post



