Headers
Headers
What do you guys think about these headers?
http://cgi.ebay.com/ebaymotors/M2-IN...item4cf9f6ba8e
I'm looking to get good headers within a good budget.
http://cgi.ebay.com/ebaymotors/M2-IN...item4cf9f6ba8e
I'm looking to get good headers within a good budget.
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods

The general consensus on here is that headers don't produce enough gains to justify the cost. Install in also a major pain in the butt.
$99 headers are not going to be good headers.
As with any good exhaust system, you get what you pay for. You can slap any ole muffler on your car, but if you are looking for any performance gains you will need to spend some money. The money you pay ( for a good set-up) covers the research and development it took to create a set-up that performs as good as it sounds. If you are serious about headers I would research them on here a bit to see what people that own them like or dislike about them. For some reason $500 range comes to mind for the install, and the same for the cost of a decent set of headers. Not a lot have them because of the high cost vs low gains ratio. Hope that helps.
As with any good exhaust system, you get what you pay for. You can slap any ole muffler on your car, but if you are looking for any performance gains you will need to spend some money. The money you pay ( for a good set-up) covers the research and development it took to create a set-up that performs as good as it sounds. If you are serious about headers I would research them on here a bit to see what people that own them like or dislike about them. For some reason $500 range comes to mind for the install, and the same for the cost of a decent set of headers. Not a lot have them because of the high cost vs low gains ratio. Hope that helps.
Gary
Thread
Thread Starter
Forum
Replies
Last Post
magnetism80
G35 Coupe V35 2003 - 07
5
Jan 27, 2016 12:57 PM
lavtxa
Engine, Drivetrain & Forced-Induction
0
Sep 21, 2015 11:51 AM
Albanian122
Engine - Exhaust
5
Sep 5, 2015 11:23 AM




