Dumb question. New to G35s and this forum. Don't know much about Nissan.

Here it goes.

Recently got a 2003 Infiniti G35 Sedan.
Car has the following mods. Injen intake. Custom exhaust, smaller pulley and Osiris tune. Nothing major.

The other day I started the car up. I drove a few hundred yards and the motor hesitated and stalled out. Won't hold any type of code. Tried pulling it multiple ways and times. Wait 30 sec. start it back up. No issues after getting warm.

Couple days later take it out. Does the same thing a couple more times. Won't store a code.

Then a couple days later does it again. Start it up. Driving down the highway in 5th gear going 60, it hesitates, service engine line comes on, goes off comes on, goes off. And then finally it stays on, the car that is not the code. Never did that before. Doesn't seem like misfire, I've had that plenty of times before. Almost seems like it's the maf sensor but am unsure cause I can't pull a code.

Just trying to see if anyone else experiences these problems at all with the g35. Suggestions would be good.

Car has 88,000 miles on chassis. Engine, tranny were replaced by Infinity dealership when car was under warranty. 10,000 on new motor.

Thx!

 

Camshaft position sensor. Won't know which one til it holds a code. It will eventually.

 

Copy. Thanks Sir

 

Both cam sensors are new. So is crank sensor.

 

If they aren't OEM that could definitely be the problem.

 

All work was done at dealership on this vehicle. Waste of money yes. Always oem though. Thanks for the replies.

 

Then take it back

Ask for a loaner and request they call you to return when they find the problem

Telcoman