Hey fellas..

I need to install my 3 guage pod w/ Autometer Nexus guages. I tore into the dash a little bit but am not sure how I am going to get the 1 wire run from the pillar to the control box over by the dash.. Can anyone shed some light on this for me?

Thanks
Ken

 

Where is the control box?

If it's on the pax side you can just run the wire down the pillar, under the dash on the driver's side, behind the center console and it will come out under the dash on the pax side. Use a coat hanger to feed the wire behind the console.

 

Yea the control box is over on the Pass. side.. My main concern was getting it run along the underside of the dash from the drivers side to the pass side.. I didnt even think of a coat hanger and will try that. There wasnt much room at all when I took the old pillar off and tried to find an opening to run the wire

 

There's lots of room there. I have my V1 wire, wires for 3 gauges, and my sunroof module wires running through there. The coat hanger is your friend.