Rear emblems
Rear emblems
Has anyone removed there rear emblems on there vehicle? Mainly the Infiniti badge? Do you know if it has the pre-slotted holes? I am looking at removing all the rear emblems and replacing them with a 350GT emblem and "SKYLINE" emblem but I am worried about the holes that might be left over by removing the INFINITI badge.
ANy suggestions.
ANy suggestions.
Originally Posted by Callaway
No holes. Use mint flavored dental wax and a hairdryer. Than goo-gone to get rid of the residue. Make sure the floss is mint flavored, very important.
Originally Posted by Callaway
No holes. Use mint flavored dental wax and a hairdryer. Than goo-gone to get rid of the residue. Make sure the floss is mint flavored, very important.
if you get frustrated with dental floss though, use a fishing line
Originally Posted by labyrinth53dj
Got it, mint flavor dental floss "lol"
Cool, now I guess I have to find a couple hours to work on it.
Cool, now I guess I have to find a couple hours to work on it.
Trending Topics
Originally Posted by labyrinth53dj
Got it, mint flavor dental floss "lol"
Cool, now I guess I have to find a couple hours to work on it.
Cool, now I guess I have to find a couple hours to work on it.

i was able to finish everything in about 10 mins.
it's not that difficult, but i suppose it's better not to rush things. take your time - just not 2 hours, hehe. good luck
Last edited by Calvin; Mar 22, 2007 at 04:21 PM.
Do yourself a favor and mark the emblem locations with tape, to simplify putting the new ones back on. Sure, they come with templates, but setting them down just above a line of tape would be a lot easier.
I used fishing line and Goo Gone to get rid of the residue.
I used fishing line and Goo Gone to get rid of the residue.
or you can do what i did and raise them a bit higher as i removed all in teh rear now i only have up near the wing nismo on driverside and 350gt on pass side but i rasied them from where the g35 was cause i felt it was too low in my eyes
but tape lines are the best,
pls dont use duct tape, masking tape man =0)
but tape lines are the best,
pls dont use duct tape, masking tape man =0)
couple of hours
Yeah what should take 10-20 min for most, don't have my wife that will keep interupting me when I am trying to do it. HAHAHAHAHAHAHAHAHA
OOPS guess I am in the dog house now.
OOPS guess I am in the dog house now.
Originally Posted by Callaway
No holes. Use mint flavored dental wax and a hairdryer. Than goo-gone to get rid of the residue. Make sure the floss is mint flavored, very important.
Thread
Thread Starter
Forum
Replies
Last Post
FS[SoEast]: 2006 DG Coupe Part Out - mrev2, projectors, etc
bu villain
Accessories
63
Aug 25, 2016 07:14 PM





