New Bumper!!!!
#16
#21
#26
#27
Originally Posted by Glex25
Beebo
Do you have picture or install manual on how the IC and the filters get routed to see how much fabrication I would need to do.
This would be a more costly solution since then I would need to change my FMIC and air intake piping.
Do you have picture or install manual on how the IC and the filters get routed to see how much fabrication I would need to do.
This would be a more costly solution since then I would need to change my FMIC and air intake piping.
pm him
#28
Originally Posted by IvoryGT
once urethane is bent in anyway..you can't fix it...you might be able to mend it a little by heating it up.
but holes..tears...say goodbye to the bumper.
but holes..tears...say goodbye to the bumper.
I had a TS urethane bumper that I got into a fenderbender with and my shop fixed it to where you could not tell at all.... They used a resin glue on the backside and body filler on the outside and it is as good as new..
I sold the bumper to G35asain for 150 and it looks great!!
You can fix it... mine had about a 3 - 4 inch crack and some scuffs as well.