I would like to take apart my clear corners for painting purposes.

What is the best way to take them apart?

I searched and found someone that used a circular saw to cut the back off.

Is there an easier way?

Thank you in advance.

 

you can see the seam on them if you look closely...one side i was able to get a flathead in there and pry apart, the other side required me to dust off the dremel....if you cut them open, you really only need a small spot along the seam and then get a small screwdriver and run it along the rest of the seam

 

^ thanks a lot. I'll mess with them tomorrow.

 

I did it over the weekend!

I started in a corner with a dremel then carefully pried them open with a screw driver.

Thanks a lot!

 

no problem