drilling for rear splashguards
#1
drilling for rear splashguards
ok so i know they require drilling but i dont have drills in mm.
but looking at inch/mm conversion ---->http://mdmetric.com/tech/cvtcht.htm
we're looking at the 5mm and 8mm..
so this is the problem, should i go bigger or smaller? i dont know if it will make a big difference but i just dont want to screw up and i dont want to go out and buy drill bits...
but looking at inch/mm conversion ---->http://mdmetric.com/tech/cvtcht.htm
we're looking at the 5mm and 8mm..
so this is the problem, should i go bigger or smaller? i dont know if it will make a big difference but i just dont want to screw up and i dont want to go out and buy drill bits...
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
FS[SoEast]: 2006 DG Coupe Part Out - mrev2, projectors, etc
bu villain
Accessories
63
08-25-2016 07:14 PM
Jiggerjuice
Brakes & Suspension
9
10-05-2015 02:33 PM