yea, my skirts had small dimples/indentions on them where all the factory holes would be...the ones in the fender wells (one in front, two in back I think) had to be predrilled along with the ones along the bottom...along my door sill I tried to use 3M doublesided adhesive, but it would not hold it tight against the car, so I am lookin to see what other people did there too also. I know some people's are just screwed into the side with/without a washer, but I was hoping from something a little cleaner.....

 

My friend just used 3m tape at the door jambs on his nismo sides and they're fine. But from what Ive heard, most ings sides don't fit that great and are pretty wavy at the door jambs. I know some guys that had to go through multiple sets of ings sides because the fitment was so bad..... I guess I got lucky with my set lol.

 

yes fitment is bad and wavey

 

Yeah thats what Ive read also.

 

i didnt put anything lol *** that i aint drilling into the car. jus tape and the screws on boths ends

 

Your not drilling into the car at all, just the skirts and the plastice tabs where the oem skirt went into.

 

yes, i had to drill those also....granted, I have the greddy skirts, not ings, but I would imagine they are all about the same...I just "dry fit" them to see where it needed to be and then drilled it out and didn't have too many problems....

 

^^i dont get it . the plastic tab is squarish and big. and the tab are inserted into a even bigger squarish hole made on the cars panel

 

You can thread a screw into the clip if it's thick enough.

 

^^o ok so u guys are using long thick screws to thread into the white sqauare clip. but technically the screw isnt holding onto much cus the clip isnt a very deep piece.

 

^...and I broke most of the white square clips when i removed my factory ones....

 

^^lol me to i think i broke 2. but its jus clips so im sure the dealer sales it

 

maybe, but then i am still trying to find a screw to fit the clip, and will prolly need a washer to dispute the weight on the hole so I don't crack the fiberglass...

 

^i ran the idea of putting drywall anchors http://img.hisupplier.com/var/userIm...101/144137.jpg in there but couldnt find any big enough. basically if u really wanna secure it like stock u need something that will open up at the tips like push pins.

 

Auveco GM Headlight Adjusting Assembly. These are what are used for Impul sides, and should work with INGS. Part # 11243

http://spaceagepaint.com/product_det...d_product=9221
http://dixie.hypermart.net/store/page21.html