I took my front bumper off and brought it to the shop for painting and when I went home, found out that my wife has sweeped the garage floor clean and threw away the 4 bolts that held the bumper to the fender.

I found 3 that may be the same ones, but when I tried to tighten the 3 bolts, none of them would tighten all the way. Both the corners have a 1" gap (corner of the front bumper that is supposed to be touching the fender).

So I guess they are too long?

I know they are 10mm, but I had another 10mm which was too thin and the other 3 were the right size just too long.

Anyone have the exact measurements of the front bumper bolts?

 

I have some big gaps on my front bumper, just found the sizes after non-stop googling:

http://wdshopsupplies.com/proddetail...S11133&cat=136
http://www.courtesyparts.com/62050ga...-p-535026.html