I am trying to remove a dent I got in my rear bumper, I was wondering if there is a detailed page I can go to for removal instructions. Any help would be greatly appreciated. TIA

Bump?

Remove plastic trunk latch cover by pulling up... 8 clips attached.

Remove rear-most trunk lining.

Remove headlights.

Remove clips for bumper underneath bumper.

Remove clips for bumper.

Remove wheel well bumper screws.

Done.

Great thread!

Once you remove all the clips, screws and bolts, don't be afraid when you pull the bumper away from the body. There'll be some snaps located by the taillights so you have to shimmy to get the bumper loose.

Tip: Use a blow dryer to help pop the dent out. Warm up the area for several minutes and use your hand to pop out the major dent portion. If you notice little dents or imperfections, warm up the area again but this time, use a rounded tool such as a screwdriver.

Wow... how come i dont see this stickied somewhere? almost everyone on the forum could use that at one time or another.