Ive looked for threads and i found some, but i need visual presentations. Im going to replace the clips in my rear interior paneling on my Gcoupe but i need to know how to take out the top (lumbar/Back) portion of the rear sets , i know how to take out the bottom portion. Sorry about this thread, i did google , but most of the threads i found are only in words or photos that dont exist on photobucket.

Thanks Again

 

hmmm i would also like to know this info also if anyone could help

 

pop the bottom of the back seat out first... then remove the top/back portion of the back seat. If I remember right there is a clip/pin on the hinge of the back seat. Pull the pin, slide the seat to the side and then it pops out. Its easy... just take you some tool out to your car and get started...

 

Thankyou , i will make a DIY of this to contribute

 

i pulled my rear seats last night so i could clean them. the seat back is secured by two pop rivets in the center and two (2) 12mm bolts (one on each side of the seat).

fold the seat down using the latch in the trunk then peel back the velcro'd edges of the seat back. pop loose the rivets in the center with a flathead screwdriver, then unhook the release wire at the bottom of the seat back (you need to peel back more of the velcro'd fabric to access this wire). use a 12mm socket to remove the bolts at each end of the seat back. the seat back is now free.

 

cool i need to do this to install some suede seats

 

has anyone completely removed their back seats?? does anyone have a picture of that?? i think it would be nice to make a custom encloser back there, you could go wild with all that space