Project: LED MODS (part2)
#1
#5
Former G35driver Vendor
iTrader: (84)
So sick, just curious though, how the heck did you open the clock, looks like you pulled the arms out. I opened mine from the back and ended up breaking the clock hahaha.
Also for the 4 pin plcc leds did you replace them with the plcc2 leds or did you buy seperate 4 pin ones?
Thanks!
Also did your airbag sensor light come on after you did this? mines going off and i cant get it off even after trying all the resetting, my obd-ll reader doesn't even pick up the code...
Also for the 4 pin plcc leds did you replace them with the plcc2 leds or did you buy seperate 4 pin ones?
Thanks!
Also did your airbag sensor light come on after you did this? mines going off and i cant get it off even after trying all the resetting, my obd-ll reader doesn't even pick up the code...
#6
You have to desolder the 6 pins (shown in the right side of my picture) and take out the center screw. be very careful not to disturb the hair-like wires wrapped around the poles. Do not solder on them too long or it will melt the plastic they are set into.
I got two pin leds, you can see in the picture I shifted them up. I found only one connection was positive the other 3 are ground.
I just did the airbag reset procedure and it took it off, mine came on from starting the car up without the compass/clock/climate unit plugged in...
I got two pin leds, you can see in the picture I shifted them up. I found only one connection was positive the other 3 are ground.
I just did the airbag reset procedure and it took it off, mine came on from starting the car up without the compass/clock/climate unit plugged in...
Thread
Thread Starter
Forum
Replies
Last Post