View Poll Results: Blue Bat or Ionic eyelids?
Blue Bat
10
33.33%
Ionic
20
66.67%
Voters: 30. You may not vote on this poll
Which kind of Eyelids? Blue bat or ionic
#16
now i get ionic's eyelids, now you get ionic's eyelids.
stop copying me!
#18
Registered User
iTrader: (10)
I knew they were the look I wanted.
Gary
#19
CLUB MODERATOR
iTrader: (24)
#20
Installed my Ionic eyelids this morning, they look just like I'd hoped. There's
one issue, maybe two....they don't come with the 3M double sided tape it
takes to install them and no where does it tell you what it takes to do the
install. I bought the 3M tape for installing body kits, it's 1/2" so you can run
the whole length of the eyebrow. In the center I stacked them 3 deep to fill
the underside of the brow. Cleaned the area where they'll attach to the
light. Turned them on edge to line up the hood points and pressed down....they're not going anywhere and fit perfectly....life is good
http://i246.photobucket.com/albums/g...yebrows001.jpg
Gary
one issue, maybe two....they don't come with the 3M double sided tape it
takes to install them and no where does it tell you what it takes to do the
install. I bought the 3M tape for installing body kits, it's 1/2" so you can run
the whole length of the eyebrow. In the center I stacked them 3 deep to fill
the underside of the brow. Cleaned the area where they'll attach to the
light. Turned them on edge to line up the hood points and pressed down....they're not going anywhere and fit perfectly....life is good
http://i246.photobucket.com/albums/g...yebrows001.jpg
Gary
#25
#28
Registered User
iTrader: (10)
Ionic....thanks Jose =)
Eyebrows, if you're doing this you may as well get the real thing. One more about installation I had issues with my tips lifting. Due to how the headlight curves the centers were stuck but the tips were lifting....so when installing don't put the 3M double sided adhesive in the center, apply it 3" back from the end of each tip. They won't lift and they're not going anywhere....perfection!
Gary
Gary
Last edited by gary c; 05-15-2009 at 09:49 AM.