I recently installed some blue B@t overlays on my taillights (which i like a lot !) but now there is condensation in my right light. Is there a way to get this out? im assuming it was just from when i sprayed the light, some water leaked in the back by the circuit board to get in the housing.
any ideas?
Thanks!

 

Dude, it'll dry and it won't take long. If you want to speed it up, leave your taillights on when you drive. Probably night where you are by now anyway.

 

ya they have been like that for a week now. just worried a bit. would throwing in a silicon packet in there hurt? like in the circuit board hole in the back