My 05 Sedan ALSO Dropped on BC Racing Coils
Joined: Sep 2005
Posts: 1,150
Likes: 1
From: San Diego, CA
then after fipping it and an alignment, it was lower, but because camber in the back was 0 it was still too high.
i got my camber kit/toe reinstalled by G35Papa on Friday. we dropped the back more.
after I get another alignment to fix the toe and add some camber, i'll upload newer pictures
Joined: Sep 2005
Posts: 1,150
Likes: 1
From: San Diego, CA
it's fine, but that rubber piece covering up the bottom engine bay... that **** is getting scrapped everywhere. i needa take it off soon before it rips off itself.
hei if u want to go lower, dont know if u have done this but of course for the rear take off one of the rings and also u can pm SFLG35 or something like that he can get hookups on SHORTER springs for the rear.. these i believe are 200mm, he can get 180mm if ur looking to be lower with these, dont know if u know that info or not but just passing it on to a fellow bc coils g
You got that right, he's slammed for sure!
I just claimed to be dropped, not slammed. I scrape enough as it is at this height.
I may lower my rear a tad, but I like the front the way it is.
I just claimed to be dropped, not slammed. I scrape enough as it is at this height.Registered User
iTrader: (15)
Shoot I thought I was low hes slammer than me!
Joined: Sep 2005
Posts: 1,150
Likes: 1
From: San Diego, CA
Front is a bit higher than originally.. gonna get a front camber kit and drop it a bit more.
Rear is still high, running 0 camber, gonna drop it and run ~-1 camber soon.

Updated Picture.
Rear is still high, running 0 camber, gonna drop it and run ~-1 camber soon.

Updated Picture.
Registered User
iTrader: (15)
Before you head down here do a side show in Oakland for us so we can see you on TV! hehe and ghost ride the whip and pull out your scrapper bike
aren't you gonna miss Norcal!?
aren't you gonna miss Norcal!?






