Maxed out on bc, anyone
#1
Maxed out on bc, anyone
Looking to buy BC coils for my sedan but I wanna see them maxed out.
So if anyone has pictures , POST THEM HERE!
I know theres probably other posts on this same thing but
..
So if anyone has pictures , POST THEM HERE!
I know theres probably other posts on this same thing but
..
#5
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,301
Received 1,486 Likes
on
1,221 Posts
G35 sedan w/ too much money in mods
#6
The following users liked this post:
jimmyboi860 (03-15-2012)
#7
ill Sedan
iTrader: (87)
I'm maxed out in the rear on one side, the other side I'm few-several threads from being maxed out. This is without removing any collars. The fronts still have room to go lower.
Trending Topics
#9
ill Sedan
iTrader: (87)
Additional to my post I'd add if you are looking to be dumped lower than me (like 4DGS, Gdup35Sedan, or Josan35) don't get BCs because you'll have to remove collars to get that low out back. I would look into Stance or F&F coils.
#11
Stance GR+ are super smooth, imo. At 6 (of 16) clicks from full stiff they are not much stiffer than stock. I think I'd have to set them a little stiffer if I was running an aggressive setup where my wheels were past my fender but I think they would still have a sporty/comfortable feel though.
I'm @ 24" to fender and the coils still have inches of thread. They can truly lay frame.
Stance GR+:
I'm @ 24" to fender and the coils still have inches of thread. They can truly lay frame.
Stance GR+:
#12
Stance GR+ are super smooth, imo. At 6 (of 16) clicks from full stiff they are not much stiffer than stock. I think I'd have to set them a little stiffer if I was running an aggressive setup where my wheels were past my fender but I think they would still have a sporty/comfortable feel though.
I'm @ 24" to fender and the coils still have inches of thread. They can truly lay frame.
I'm @ 24" to fender and the coils still have inches of thread. They can truly lay frame.
#13
ill Sedan
iTrader: (87)
My wheels poke so I have to run them at full stiff so I'm not constantly hitting the lips of my wheels against the rear quarter panel. The ride is much stiffer than OEM, but I'm used to it.
My specs are 9.5 +5, 10.5 +18
My specs are 9.5 +5, 10.5 +18
Thread
Thread Starter
Forum
Replies
Last Post
invincible514
G35 Sedan V36 2007- 08
7
09-21-2015 07:05 PM
baker2795
Engine, Drivetrain & Forced-Induction
3
09-02-2015 06:00 PM