are you running H&R springs?

 

Man i pulled mine off after 12ooo miles to clean my brakes up....they are down to 1mm of tread on the inside shoulder only. A friend recommeneded i have a tire shop swap the tires from left to right and right to left.

Its a great idea that i cannot wait to do, but i am worried about a shop digging into the rim to dismount and remount tires on. I have kept them mint for this long, i dont want a tire shop messing that streak up.

I know under 35 sidewall and over 20" rim is hard to do by the shows i have seen on tv. anyone recommend a certain chain of tire shops(national ofcourse)

 

Looks sick in white

 

no im running Tanabe DF210

 

12k is too much, if u want to keep them somewhat even wear u have to have flip every 5k-8k miles. also look for shops that often deals with expensive wheels then u should be fine.

 

Man that sucker is low. I love the night shots!

 

thx for the compliments!

 

What are the offsets if you don't mind me asking?

 

they're 19x9.5 +35 and 19x10.5 +40

 

Any rubbing at all with those offsets? I'm looking at some rims that are 20x9.5 +35 at all 4 corners.

 

They shouldn't rub at all... theoretically.

 

so... doesnt seem to be a SPort.. so then it must be AWD ..you havent had any issues running the staggered setup you have? reason i ask is everyone says the same thing and in the instruction manual even says not to run staggered setups since it will mess up the AWD system.

 

good job man, i like

 

no rubbing at all, even with full load

 

whata s SPort? the car is RWD not AWD