G o l d e n g a r d e n s: N o r t h w e s t n i s s a n 2 0 0 9
Tell me about it! You should come by the house and we can do another detailing session. Clay bar, porter cable, etc...
The problem with that is if I do go to this, then I will be on the mountain Saturday for sure, and there just isn't enough time in the evening to get in a detail without pulling an all nighter.
i've got a few G35Driver stickers that i made up for the NW toy run still left over. i've got silver and white if anyone wants a pair (please 
). $8 a pair, just trying to recoup the money i spent to get them made up. i'll try and get a pic of the ones on my car later today for reference. 
). $8 a pair, just trying to recoup the money i spent to get them made up. i'll try and get a pic of the ones on my car later today for reference.
here's what the G35Driver stickers i had made up look like:
you can also see my newest mod in the second pic, the sweet door ding! some asshat decided they didn't care as much about my car as me while it was parked at work.
you can also see my newest mod in the second pic, the sweet door ding! some asshat decided they didn't care as much about my car as me while it was parked at work.
lol' this fool has his trigger finger itchy....
They look good from that shot though'
BTW. I'm going to need help installing my suspension before the meet. I am supposed to go up to Ernie's but that's a trek for me. My hand is fractured and i can't hold the impact gun without crying'
They look good from that shot though'
BTW. I'm going to need help installing my suspension before the meet. I am supposed to go up to Ernie's but that's a trek for me. My hand is fractured and i can't hold the impact gun without crying'
well they are the fake multi-piece look with the fake bolts around them. i thought they were plastic so i left them in to get burned out in the oven when i got them powder coated. turns out they were metal and now they're powder coated in. they press in kind of like a wheel stud. i need to figure out a way to get them out so i can order some new ones that are chrome. they'll look 100x's better once i get that finished. i was gonna try to dremel around them but there's less than 2mm clearance. i wish i had a drill press. i could put them on a flat table and drill them out easily, they should be a pretty soft alloy. just haven't got around to it yet. probably will after GG met.
