What did you do to your car today....
#1354
you shouldn't have to run any wires, just connect factory harness plug into the TV, then plug into car... wires just push back.
#1357
#1358
Just had done...
Oil cooler O-ring (one that came out was still like new so guess it had been replaced previously)
Oil pan gasket (rtv)
Oil change (5w30) and new filter
Greased rear axles (valvoline synpower grease)
Found out...
rear brakes are at about 20% remaining (guess that will be next)
there is some build up inside the engine (at least in the oil pan area), nothing excessive but there just the same
Still to do...
Cabin filter, clearance bulbs and a couple noise fixes (behind rear seat - brace in trunk and passenger seat - bottom plastic cover)
Jason
Oil cooler O-ring (one that came out was still like new so guess it had been replaced previously)
Oil pan gasket (rtv)
Oil change (5w30) and new filter
Greased rear axles (valvoline synpower grease)
Found out...
rear brakes are at about 20% remaining (guess that will be next)
there is some build up inside the engine (at least in the oil pan area), nothing excessive but there just the same
Still to do...
Cabin filter, clearance bulbs and a couple noise fixes (behind rear seat - brace in trunk and passenger seat - bottom plastic cover)
Jason
The following users liked this post:
ThatOneDude (07-17-2011)
#1362
http://my350z.com/forum/brakes-and-s...mount-mod.html
i did not cut them my self because i bought them precut. but i did notice that my drivers side would sit higher than pass side and it would bug the crap outta me. so i installed the slightly smaller one on the drivers side and it looks perfect now. i will post pix soon hopefully i jus have crappy phone pix right now.
i did not cut them my self because i bought them precut. but i did notice that my drivers side would sit higher than pass side and it would bug the crap outta me. so i installed the slightly smaller one on the drivers side and it looks perfect now. i will post pix soon hopefully i jus have crappy phone pix right now.
#1363
Had to replace the valve cover gaskets as both sides decided to leak. Fak. Then washed the car this afternoon and got rained on driving into town. Fak me. Car was clean like for half an hour. Got home from the gym and rewashed the car. Pulled it into the garage. Plus I believe my passenger side window motor is failing. Joe can u get a group buy on those.
#1365