*Official Painted/mod Headlight/taillight Thread*
Here are mine.
I did not put any around the projectors instead I added a few leds inside the "oragne turn signal light" as I switched to a projector lens inside.
As for the color, they appeared to white/blue/purple, depending on the angel you look at them. To much color at first, but look good now. Might get a new set and try a different K.


I did not put any around the projectors instead I added a few leds inside the "oragne turn signal light" as I switched to a projector lens inside.
As for the color, they appeared to white/blue/purple, depending on the angel you look at them. To much color at first, but look good now. Might get a new set and try a different K.


Registered User
iTrader: (15)
Joined: Aug 2003
Posts: 1,846
Likes: 9
From: Toh-rensa,Ahteesia,Ahcadia,Montree Pak, Longa Beacha
I'll bring a bunch next time I make it out to a meet. Unless you're in a hurry for these.
Registered User
iTrader: (15)
Joined: Aug 2003
Posts: 1,846
Likes: 9
From: Toh-rensa,Ahteesia,Ahcadia,Montree Pak, Longa Beacha
I only wish the oznium leds came with silver or white circuit boards and not orange.
I already did my side markers a while back. I was just too lazy to put them back on, since I'm going to swap out my headlights again fairly soon.
Here's a pic of my side markers:

A pic in the daytime. They were just $5 ebay ones, so nothing special in the daytime.

And a preview of my current headlight project. The TLs on the bottom I've had before. Everything is already rotationally set, and the aiming is already done. I'm using a computer power supply that can power up two ballasts at a time.
I already did my side markers a while back. I was just too lazy to put them back on, since I'm going to swap out my headlights again fairly soon.
Here's a pic of my side markers:

A pic in the daytime. They were just $5 ebay ones, so nothing special in the daytime.

And a preview of my current headlight project. The TLs on the bottom I've had before. Everything is already rotationally set, and the aiming is already done. I'm using a computer power supply that can power up two ballasts at a time.
Registered User
iTrader: (15)
Joined: Aug 2003
Posts: 1,846
Likes: 9
From: Toh-rensa,Ahteesia,Ahcadia,Montree Pak, Longa Beacha
A few progress pics. I really want to finish this project so I can finish up some other pending ones.
Driver side aiming. This is from about 60 feet away, the camera was zoomed in somewhat.

How the top shroud will look. I'll secure it permanently after I trim the bezel from the headlight.
Driver side aiming. This is from about 60 feet away, the camera was zoomed in somewhat.

How the top shroud will look. I'll secure it permanently after I trim the bezel from the headlight.
Registered User
iTrader: (15)
Joined: Aug 2003
Posts: 1,846
Likes: 9
From: Toh-rensa,Ahteesia,Ahcadia,Montree Pak, Longa Beacha
Don't worry, it's just sitting here. I gathered up all my spare bulb sockets and put them in a bag.





