damn! that looks HOT!

 

I might get them no I am just kidding I thought about it but i am getting another set of wheels 20s likely a little less aggresive in size from what I have now.

Tax return?? I heard you guys might be getting IOUs from the govt this year...not being a dick but I heard something like thatI would be pissed if that happened to me. I hope you do get the WORKs I think it would take wider front frnders to fit them though. If I have time I will pull out a tape and do some math on it. If they dont fit stock front fenders I was thinking the CF fenders one of the vendors was selling are like 10mm wider than stock that would work. But I guess thats even more $$$ it would be sick though.

 

haha yah cus the seller had a good pic of it lol but obviously they will be less shiny than that in person, the pic of the wheels wus in daylight and ur car is in the night so yah but there u go

 

i think were getting IOU's from the state.

 

Yeah the front are the only think making me iffy, they they were 10.5 with that offset id be so much better, these will stick out about 30mm further than my current setup(9.5 +14). But i plan on pulling my fenders anyways sooooo....well see!

 

holy **** i just saw that...19x11 19x12.. wow.. lol flaaared fenders haha

hahah by the way i love the thread jack haahaha

 

hahaha! less heat to the OP!

is your coils maxed out shane?

 

^Nope, but if you want me yo go lower and still drive at all, it's not possible lol less than 1.5" ground clearance is good enough already hahaha

 

wut is this "ability to drive" you speak of?


lol

 

Just a note to those trying to figure out the offset, Work only measures the flat part of the lip and stops where it begins to bend downwards. So take 1/2" off the OP's measurements
20x10 (3.75 Lip Front) ~ 3.25"
20x11 (5.25 Lip Rear) ~4.75"

Convert to mm and look up on Work's site, if they're not custom, then they are most likely this:
20x10 +11 R disk
20x11 +19 O disk

 

Makes sense.

According to WORK's spec sheet. If the rear is truly 5.25" lip then the offset be about -5 offset on with O-Disk
and front 3.75" lip be about 0 offset on R-Disk.

 

haha nice

 

sigh...

MAX LIP for work 3pc 20in is 122=4.8in...nothing beyond that, 5.25 is fantasy...if you want more you have to go 18's

all the offsets available are on the sheet. no in between offsets...no custom offsets, only available offsets to order are on the sheet.

 

That's what I meant. What I said was just an example of those rims if were to be custom offset.

 

Wow, that looks awesome!! What are the specs on those??