sounds pretty good but the drone is a bit high.
what y -pipe do you have?

^stock Ypipe

PPGFREAK just informed me that my diffuser will be done sometime next week
stay tuned

sounds mean

^thanks patman


(question,those led's that you have on your front bumper,
where did you wire it to?)

the clear corners

was the install hard?
do you buy a connector cord to the clear corners ?

i just used a wire connector and spliced the wires and connected, then wrapped up with electrical tape.. not much to it

hey sry to keep asking you questions lol
but can just buy any wire connector?
b/c i found the vendor on ebay selling your leds.actually its
the same leds that you purchased.

thanks again

yeah i just used some generic ones that i had lying around..

back on topic haha.. so is your single outlet diffuser basically going to cover the stock oem bumper exhaust outlet area on the right side?

thanks patman

back on topic indeed

my rear diffuser will look like zackt69's
but mine will be wrapped in carbon fiber

made a short drive by video,
go to page 1 post #2

any updates from ap about the mid pipe?

eddie from THMotorsports
has not sent me any updates
but from what im hearing the mid pip is suppose to
have that indent, i duno why

Damn, exhaust sounds sick.

I don't know if I could handle the drone though.


Props, O HELLA OEM.