What did you do to the G today?
#6601
The following users liked this post:
Lartytiejdke3 (10-30-2016)
#6602
The following users liked this post:
Urbanengineer (10-31-2016)
#6605
I drove ttrank's car solo
iTrader: (50)
Join Date: Mar 2009
Location: By the sea, Tx
Posts: 18,299
Received 1,486 Likes
on
1,221 Posts
G35 sedan w/ too much money in mods
#6606
#6609
Over the last few days...
Installed new OEM radiator, water pump and thermostat.
While I had the radiator out I swapped over to the AMS lightweight pulleys I've had for months. Since the crank pulley was off I replaced the front crank seal..not leaking yet but hey, 126k miles is a good lifetime for it.
I fixed an oil leak I discovered from the back of the oil filter housing. The center mounting stud (that the oil filter screws onto) just needed tightening.
Also painted the grilles for the Inven bumper satin black and installed them, installed the cold air drop down pipe on the K&N Typhoon that came with the car. And finally, relocated the GReddy catch can to between the engine and firewall on the passenger side. Really cleaned up the look of the bay.
All this done over friday and saturday. Pics on my phone.. i'll post later.
Installed new OEM radiator, water pump and thermostat.
While I had the radiator out I swapped over to the AMS lightweight pulleys I've had for months. Since the crank pulley was off I replaced the front crank seal..not leaking yet but hey, 126k miles is a good lifetime for it.
I fixed an oil leak I discovered from the back of the oil filter housing. The center mounting stud (that the oil filter screws onto) just needed tightening.
Also painted the grilles for the Inven bumper satin black and installed them, installed the cold air drop down pipe on the K&N Typhoon that came with the car. And finally, relocated the GReddy catch can to between the engine and firewall on the passenger side. Really cleaned up the look of the bay.
All this done over friday and saturday. Pics on my phone.. i'll post later.
#6613