just shoot me a PM im ready for this

im still down, i got a small dot on my left door, it is hit by another car in the parking lot...

Okay... lets start organizing this... we'll give this until the end of the week... and then based on the number at that point (lets say Saturday)... is it okay that you confirm w/ your guy MEXTEP?

As long as I can get some true interest he is pretty flexible with me. too bad <y wife has MISPLACED my digi so as to get the pics up

//s92.photobucket.com/albums/l36/mextep/


This si the best that I can do when it comes to posting pics.(I'm not computer friendly)

It's the 4 first pics of the finished product....you may not notice any damage and that's because the work has been completed. the dent was right on the crease above the wheel on the lower part of the fender about 3 inches from the turn signal.

If someone can post them into the thread, even better.

I think the best that can be done to your car by a PDR person is to get the dents out and then color sand the area but just to minimize the damage but really doubt he will be able to get this out with out painting the damage.

damn, do you know how much this would cost me???? any info would be appreciated.

Thanks guys!

I have a pretty large dent like the size of my phone (Motorolal SLVR) along the side of my rear 1/4 panel right where the clear film is at. Does anyone know how they will go about fixing it and how much? It looks like it needs to be drilled to get behind the panel.

I got the pics but they are too large and as you've noticed I have a hard time on posting them...can any one post them if I e-mail them? if so post your e-mail....these are the before and after pics along with pics of them repairing 2 bumpers.

Here you go buddy!

Thanks LJN.

I still have the before and after in my e-mail..can I send them to someone so they can post?

Is there still any interest so i can speak with my buddy about getting a better rate?

im down... i got a small dot on my passenger door.

I'm somewhat interested but my ding is very small and hardly noticeable (of course I notice more than anyone)... anyway it was mentioned earlier that a crease is considered "critical" and costs $125... It's not worth it - if you saw it you would agree... so I'm afraid I'm out on this one.

$50 bucks per dent! PERFECT for those of you who just have a single dent, anybody interested? The guy's in IRVINE. Looks like the date is going to be set for WED (time is still pending).

Those of you with more than two, let me know and I'll see if he can just do 50 for per panel.

mine is very small, im still down... much smaller than a quarter...