sways loose..no all tools..need help!!!! (310)
#1
sways loose..no all tools..need help!!!! (310)
i put my hotckis sways on a couple weeks ago with the help of a buddy. at lunchtime today, i started getting a rattling underneath the car - probably the sways, i'd say. more than likely, an endlink bolt is loose.
every car buddy i know is out of town or busy, and i don't have a jack, jackstands, or torque wrench.
anyone on the westside with those tools able to help me out?
every car buddy i know is out of town or busy, and i don't have a jack, jackstands, or torque wrench.
anyone on the westside with those tools able to help me out?
Last edited by bwassul; 11-02-2006 at 07:37 PM.
#4
Red Card Crew
iTrader: (24)
Bah, screw the torque wrench. If the bolt/nut is on the end link, they are both stainless steel. Which can tolerate a big variance in torque. As you probably know, too loose is probably worse then 10-30% too tight. When I was taking off all my nuts/bolts during my install, I noticed big variances in how tight stuff was. Swaybars aren't that critical for torque.
If you get a small 3/8" drive socket set with the short 12" handle, I doubt you would be able to overtorque these bolts to the point of breaking them anyway.
If you get a small 3/8" drive socket set with the short 12" handle, I doubt you would be able to overtorque these bolts to the point of breaking them anyway.
Thread
Thread Starter
Forum
Replies
Last Post
rezendvous420
G35 Sedan V35 2003-06
10
05-31-2020 01:26 PM