TechnoSquare ROCKS!
Originally Posted by rookie
The 6mt conversion has been mostly done for a while now, the problem they were running into was the driveshaft was too short, I gave them the FX companion flange (driveshaft connection to the diff) which is a little longer. Not sure if it helped or not, they'll get it done and smoking tires when the time permits.
Looks great Eric.
... but what's w. the reverse control and the blind spot?
Ya should have tried to get in touched w. me. I would have helped you install and rewire them to work normally.
... but what's w. the reverse control and the blind spot?
Ya should have tried to get in touched w. me. I would have helped you install and rewire them to work normally.
Joined: Sep 2004
Posts: 9,524
Likes: 3
From: So. Cali - Rowland Hts
^ I'd do it myself if I can read the MIRROR diagram =( lol I dont get this thing tho it only has three wires and a ground.. the LEFT and RIGHT adjustments are through ONE wire? O.o the blind spot on the driver side is there because it was obviously made for right hand drive.. If I set in the passenger side I can adjust the mirrors to be PERFECT sitting in the driver seat the driver side mirror just doesnt adjust enough
- Eric
626-636-6678
- Eric
626-636-6678
Originally Posted by Klumzyee
^ I'd do it myself if I can read the MIRROR diagram =( lol I dont get this thing tho it only has three wires and a ground.. the LEFT and RIGHT adjustments are through ONE wire? O.o the blind spot on the driver side is there because it was obviously made for right hand drive.. If I set in the passenger side I can adjust the mirrors to be PERFECT sitting in the driver seat the driver side mirror just doesnt adjust enough
- Eric
626-636-6678
- Eric
626-636-6678
uhmm ... I can read some Japanese and 3 wires are exactly all that you'd need for 2-axis controls (ground, left/right, up/down). Your wirings are mixed up and expected adapting from RHD units w.o. repatching.
EE FTW!
Holler next time.
Last edited by THX723; Nov 27, 2007 at 05:03 PM.
Originally Posted by THX723
uhmm ... I can read some Japanese and 3 wires are exactly all that you'd need for 2-axis controls (ground, left/right, up/down). Your wirings are mixed up and expected adapting from RHD units w.o. repatching.
EE FTW!
Holler next time.
Originally Posted by THX723
... if only the quiz was in Japanese. 
