Bought these springs about a week ago, but im deciding to go into a way different set up with my suspension. Never used by me. Spring mounts were bought brand new, went to a shop and had them professionally cut to be even and for the best drop possible. Never have seen miles on my own behalf.

Sold!

Camber is only recommended for rears. Fronts are not necessary but can be used!

Can be used for:
03-07 G35 coupes
03-07 G35 sedans

 

what is the dropped i should be expecting? pm me

 

The H tech 350z springs drop a G .8" front and .7" rear.
Without the springmount mod. You wont see a very noticeable drop in the rear, but with them, you'll have one clean and aggressive drop.

 

How much was cut on the spring mount? How many inches?

 

Damn, to tell you the truth, I do not know. The shop has done them before for our cars and I just asked for lowest possible without issues. I can imagine an inch or a inch and a half.

 

Dang! Was actually looking for this man! But just wanted half an inch or an inch max cuz im running fat tires! What set up was this supposed to go on to?

 

You should be fine. I Dont think you can cut them past an inch and a half without future issues. It was going to go on OEM 19 Rays, with 225 fronts and 245 rear but like I said, im going different ways with my suspension. Unless your running anything over 275, you'll be fine, might need to roll your fenders as worst case scenario.

 

Im actually running 19x10.5 rears with 285/35/19 and rolled fenders

 

Damn lol, well its your call. Might need to do some research beforehand.

 

Yea man! That sucks! I just have about a finger clearance ryt now so most likely one and a half inches would b too much! =(

Well thanks anyways man! Glws! =)

 

post pix of the spring mounts from the side - we can tell how much has been cut that way. you shouldn't cut much more than 1/2" off, btw.

 

Picture upon request for springmounts. same height as a penny as shown in picture.

 

bump

 

bumpp

 

bump