Cheap mechanical work for you AZ guys.
Joined: Feb 2007
Posts: 688
Likes: 2
From: Surprise, Arizona
Originally Posted by MotherOfPearl
Still getting into the ownership groove, and wanted to check price for a 30K checkup?
Thanks in advance
Thanks in advance
what the hell man!...
where the hell were a few months back when i wanted someone to install my greddy sides??
i didnt feel like doing them in the parking lot
i will definitely look to you for some work later down the road
where the hell were a few months back when i wanted someone to install my greddy sides??
i didnt feel like doing them in the parking lot
i will definitely look to you for some work later down the road
Joined: Feb 2007
Posts: 688
Likes: 2
From: Surprise, Arizona
Originally Posted by Z 2 G
what the hell man!...
where the hell were a few months back when i wanted someone to install my greddy sides??
i didnt feel like doing them in the parking lot
i will definitely look to you for some work later down the road
where the hell were a few months back when i wanted someone to install my greddy sides??
i didnt feel like doing them in the parking lot
i will definitely look to you for some work later down the road
Joined: Feb 2007
Posts: 688
Likes: 2
From: Surprise, Arizona
Originally Posted by ninous26
John, do u know if 350z cats fit a G35??? I've asked everyone and nobody is sure about it.
Originally Posted by Sir Boostalot
Honestly I have no idea. You should post a thread in the tech section and see what everyone says. You could always make them fit. 

No replies here, or my350z.
It would be interesting to modify the cats.
Originally Posted by ninous26
No replies here, or my350z.
It would be interesting to modify the cats.
It would be interesting to modify the cats.
I'm pretty sure that the cats from a Z and G are the same. I think the only thing that really changes between the two is the length of the exhaust from the cat-back. That's why Nismo exhausts for a Z will fit a G with an extension. I'm not sure about Non Rev vs. Rev-up engines though.
Joined: Feb 2007
Posts: 688
Likes: 2
From: Surprise, Arizona
Originally Posted by mfshin
Have you done compression rod bushing work?
As i understand, it requires press bench or similar equipment.
I need to tackle this dreaded squeaky noise.
As i understand, it requires press bench or similar equipment.
I need to tackle this dreaded squeaky noise.
Hey john coming up on my 60K warrantee how much are we looking at? Also was curious if you know of anywhere to get the vinyl for taillights for a cheap price and also if you installed? let me know thanks, chris


