My '03 IP Coupe
#1
02-26-2013, 08:06 PM
My '03 IP Coupe
Just sharing some pics of my coupe and a few changes i've made so far..
First picture taken the day after i bought the car 9/12
tinted the windows 20% all around and 50% full windshield, jdm clear bumper lights
matte black vinyl top that i was super unhappy with when i first got it done but it grew on me. i still want to have it done over with gloss black instead though
vossen wheels 20x9 in front w/ 245/35 tires and 20x10.5 in rear w/ 285/30 black and machine finish with chrome lips
installing new pioneer avic-z140bh with jdm double din dash kit..
also replaced interior bulbs with white leds and added z-tube and k&n filter. have a 5/16 spacer but was damaged being shipped so i have to wait for a replacement. should be installed soon though.. my next thing will be lowering springs. im trying to decide which ones to go with. i do not want to lower my car more than an inch and still want to keep the same ride
First picture taken the day after i bought the car 9/12
tinted the windows 20% all around and 50% full windshield, jdm clear bumper lights
matte black vinyl top that i was super unhappy with when i first got it done but it grew on me. i still want to have it done over with gloss black instead though
vossen wheels 20x9 in front w/ 245/35 tires and 20x10.5 in rear w/ 285/30 black and machine finish with chrome lips
installing new pioneer avic-z140bh with jdm double din dash kit..
also replaced interior bulbs with white leds and added z-tube and k&n filter. have a 5/16 spacer but was damaged being shipped so i have to wait for a replacement. should be installed soon though.. my next thing will be lowering springs. im trying to decide which ones to go with. i do not want to lower my car more than an inch and still want to keep the same ride
Last edited by UR2klose; 02-27-2013 at 09:16 AM.
#4
02-26-2013, 10:04 PM
#5
02-26-2013, 10:12 PM
Looks great. Vossen wheels are the way to go. I like Eibach's personally. Haven't seen the exact drop on a G yet but the search button yields great results.
Some spacers would be a nice way to go, however if you can go to NAPA and get replacement studs. Only reason I say that is because I bought 25mm spacers with the original studs and busted a wheel when I drove away. Sheared three studs off clean when I hit a pot hole. I think it was TOO BIG at the time, needless to say it was a pricey mistake.
Looking forward to seeing more progress pictures. Any chance you can get interior shots with the new LEDs and the Z tube and the like. I'm a stickler for engine bay pics.
Some spacers would be a nice way to go, however if you can go to NAPA and get replacement studs. Only reason I say that is because I bought 25mm spacers with the original studs and busted a wheel when I drove away. Sheared three studs off clean when I hit a pot hole. I think it was TOO BIG at the time, needless to say it was a pricey mistake.
Looking forward to seeing more progress pictures. Any chance you can get interior shots with the new LEDs and the Z tube and the like. I'm a stickler for engine bay pics.
#6
02-27-2013, 09:12 AM
#7
02-27-2013, 10:03 AM
The following users liked this post:
UR2klose (03-01-2013)
Thread
Thread Starter
Forum
Replies
Last Post
djreinx
Engine - Electrical
3
12-10-2015 01:48 AM