All -

I have a complete VQ35DE Rev Up that I'm parting out. Right now everything is up for sale including internals such as:

Cylinder Heads
Valve Covers
Block
Front Cover
Timing Chains
Cams
Crank Shaft

All accessories are available as well (All have 11k miles):
A/C
P/S
Oil Pump (31k)
Alt
Flywheel (11k face looks fine)
Clutch (11k plenty of material left)
Complete Intake
Thottle Body


Why you ask? This engine had 31k miles on it with a Oil Consumption problem. According to Nissan/Infiniti this is related to the rings on the pistons. The block itself is sound.

So why wasn't it covered under warranty? Funny you should ask... Nissan/Infiniti likes to punish those of us that modify our cars with things such as intakes and exhausts... Ridiculous I know but that was my fate. I purchased a used engine with 11k miles on it and now I'm selling the unused accessories and other parts that I had duplicates. As we all know the parts are more valuable then an entire engine.

Right now I have one of everything so just ask if you need a specific part and we'll work a deal. I plan on getting things up on eBay as well but thought I'd try this first and see if there was any interest. As the parts are sold I will post them PM me with requests and I'll get back to you as soon as possible.

EDIT:

Also have a set of Brakes Front and Rear probably had about 20k miles on them before I upgraded
Full cat back exhaust (Stock) has about 5k miles on it
L/R Cats have approximately 15k miles on them
Extra lower plenum (stock) from MREV replacement had about 5k miles on it
Air box assy - Everything but the MAF sensor
UPDATED: Complete A/T engine harness
Also have a full set of Springs (front and rear)

I also have a "blown" IPDM and ECU, that was a stealership diagnosis but I understand it's VERY difficult to blow the IPDM and it's most likely a relay It's up for sale if anyone wants to work thru diag just make me an offer.

As you see below I don't have the starter to this motor.


SOLD:
Front Cover (Outer)
Block (Block only, still have pistons, rods, crankshaft and lower end available.)
Upper and Lower Oil Pan
Crankshaft
Crankshaft Girdle
Main Bearing Caps
Camshaft Sensors
Flywheel
Alternator + Bracket
Flywheel Bolts
Clutch Bolts

NEW:
Have a CD009 Transmission with 32,000. Whines a bit but works fine diagnosis is a main bearing which can be replaced. Make me an offer.

 

Dude intake and exhaust wont cause oil consumption. Get a lawyer and fight

 

how much for the upper plenum shipped to 07458

 

Do you have the starter?

If so, how much shipped to 85085?


Thanks

 

how much for complete intake shipped to 94501

 

Are you looking for the air box to the throttle body? If so, I don't have it complete, I do have the air box but it does not have the MAF.

 

Sorry had to use the starter on my new engine.

 

You know that, I know that... Nissan doesn't give a sh@t. Their pockets are slightly deeper than mine and I've already been through 4 months of battling with them. My next move is States Attorney Consumer Affairs Division.... Right now I'm trying to decide who to go after first. The dealership or Nissan.... What a PIA.

 

$160 for the upper plenum (not including throttle body)

It will ship from 20871 and it weighs around 10 lbs. If you're interested pm me your full address, I'll get a more detailed shipping quote, fedex, ups, whatever, I'll run it and send it over to you. Shipping will be whatever it costs I won't add anything to it.

 

I could use the block......how much picked up?

 

In what city are you located?

 

Shot you a PM

 

would you have enough clutch parts to do a tranny swap from auto to manual? if so how much for it all?

 

Hey in your signature says you got ztube, you selling that by any chance?

 

You would need a M/T wiring harness (I don't have that)
Tranny (don't have that)
Clutch and new flywheel (do have both)

plus the center console and shifter, removal of your A/T computer and a reflash of the ECU. That's a big job!

In summary, no, I just have the clutch and flywheel.