I was wondering if anyone out there has gotten this Steering wheel control box to work. The instructions for PAC stink to put it politely. If any of you have I could sure use some help. Thank

 

Are you having a problem with wiring or programming?

 

Not sure. I'm having problems when trying to program but it could be because of the wiring. I have the mode set to 3 but when I try to program the volume up the led stays on then flashes 3 time which I think means that the programming is done.

As far as the wiring goes I have the 150 ohm resistor to pin 23 (Green wire) and the 47 ohm resistor to pin 22 (Red). Then the two resistors connected to the white wire of the PAC harness. I have attached the pin 25 (Yellow) to chassis ground.

 

You did wire it correctly. You might need to check your connections, the light should definately go off when you press vol up. Make sure that ground wire is ok.

 

Thanks I'll have to take another look at it tonight.