Viper 5002 alarm problems
Viper 5002 alarm problems
i have a Viper 5002 alarm. it has a mind of it's own. it keeps going off, telling me my trunk/hood is open, and my warn away goes on too. what is casuing this problem? i adjust my sensitivity level and it still happens. i had a Prestige alarm prior to my Viper and it was doing the same thing. at first i thought it was the Prestaige alarm itself, so i went with Viper. thanks in advance...
did you use relays to isolate the door pins and hood/trunk pins? well maybe not the hood pin because you get that from the pin switch. did you use diodes on your connections for the door, hood, trunk pins?the reason for that is because on our car the BCM goes into a power save mode after 10 or 15 mins i believe to save power; therefore cause the alarm to think that it was triggered. if that's not the cause then maybe it's a bad module.
Last edited by bngu1; Mar 10, 2008 at 12:15 PM.
i would have to check with my installer. if it goes into power save mode after 10-15mins, it should only alert me once.....no? i already been through 2alarms. do i have such bad luck both were messed up.
if this was professionally installed then they should have known of this problem. when it goes into power save mode and set off the alarm it actually wakes up the car and goes back to power save mode again after a period of time.
Last edited by bngu1; Mar 10, 2008 at 01:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
itgogitrev
G35 Sedan V35 2003-06
1
Sep 23, 2015 07:08 PM




