Alright I've been to lazy to install this little unit because i got stuck where to hook up the red wire with the fuse and the yellow wire from the dei shock sensor unit. I stripped the wrong wire from the wrong harness in the BCM, it was red and black like the DIY suggested but it was not 12v.

Anyways to those who install these yourselves can you help me out on which harness (black and red wire) to splice. Does it have to be in the BCM? cause i got like two harnesses that measure 12v but its not in the BCM. Thanks in advance.

Mod's please don't move this to electronics becuase it don't get alot of traffic.

 

follow my diy in the electrical diy section
the wires you need are at the ignition harness.

 

yea i'm trying to find this ignition harness.



is it those harneses above the fuses? I really don't wanna strip another wrong wire.

 

the ignition harness is not at the bcm
its at the ignition aka where you put your key in.

 

"take off plastic panels to gain access to the bcm and ingition wires"
i was under the impression it was behind the plastic board, that's why it doesn't make sense. bah thanks i'll check it now