Minimal audio install
Joined: May 2006
Posts: 1,119
Likes: 1
From: Sacramento, CA
just a quick update:
yesterday while driving home, i noticed when i made a sharp turn that the amp would cut out, then come back on..
when i got home i pulled on the remote on wire and it pulled right out. this being a used amp, the hex screw for the remote on is fairly stripped.. even a torx bit i had wouldn't make it any tighter. this was after stepping the wire up to 16AWG speaker wire via butt-splice.
so i pulled it out, turned on the Signal Sensing and haven't looked back. the amp basically looks for an sound signal on the RCA inputs and powers the amp if it sees it. seems to work just fine.
yesterday while driving home, i noticed when i made a sharp turn that the amp would cut out, then come back on..
when i got home i pulled on the remote on wire and it pulled right out. this being a used amp, the hex screw for the remote on is fairly stripped.. even a torx bit i had wouldn't make it any tighter. this was after stepping the wire up to 16AWG speaker wire via butt-splice.
so i pulled it out, turned on the Signal Sensing and haven't looked back. the amp basically looks for an sound signal on the RCA inputs and powers the amp if it sees it. seems to work just fine.
Joined: May 2006
Posts: 1,119
Likes: 1
From: Sacramento, CA
Thread
Thread Starter
Forum
Replies
Last Post
Z1Motorsports
Suspension-Vendor
56
May 31, 2020 01:56 PM
Hotdawwgman
Audio, Video & Electronics
7
Sep 18, 2015 04:19 PM
